Could I help you?
New Reduced price! View larger

ASTM D6195-03(2019)

New product

ASTM D6195-03(2019) Standard Test Methods for Loop Tack

standard by ASTM International, 08/01/2019

More details

$21.12

-56%

$48.00

More info

Full Description

1.1These test methods cover the determination of properties of a pressure-sensitive adhesive. These test methods are applicable to those adhesives that form a bond of measurable strength rapidly upon contact with another surface. Tack force may be measured as the force required to separate the adhesive from the adherend at the interface shortly after they have been brought into contact under a load equal only to the weight of the pressure-sensitive article (for example, tape, label, sticker, etc.) on a 1 in. contact area.

1.2The following test methods are included:

1.2.1Test Method A(using Tensile Tester), and

1.2.2Test Method B(using Loop Tack Tester).

1.3The values stated in inch-pound units are to be regarded as the standard because the industry standard width for pressure-sensitive tape is 1 inch. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Product Details

Published: 08/01/2019 Number of Pages: 5 File Size: 1 file , 160 KB